1.Modify the display language of Cura.
Click in turn: “Preference”-“Configure Cura”-“Language”.



2.After inserting the SD card, the printer did not respond.
First, in Cura, set the parameter setting display part to “All”.
Insert the SD card and choose to print, the screen shows that the timer starts, but it does not print.
In the “material” option in Cura, set all temperatures to 0°C.
3.How to set the model to print only a single-layer outer wall?
In the “special modes” option in Cura, check the “spiralize outer contour” part.
4.How do I remove the “Brim” setting around the model?
To make it easier for the model to stick to the surface, the Birm setting is turned on. If you need to turn off the Build Plate Adhesion setting, you can change it from “Brim” to “None” according to the picture, and the blue line will disappear.
